Product category: Batteries and Chargers
News Release from: Maxim Integrated Products | Subject: DS2786 stand-alone battery capacity gauge
Edited by the Electronicstalk Editorial Team on 22 February 2007
Accurate battery capacity gauge
A stand-alone, open-circuit-voltage (OCV) based fuel gauge estimates the available capacity of rechargeable Lithium-ion batteries using a combination of an OCV battery model and coulomb counting.
Dallas Semiconductor's DS2786 stand-alone, open-circuit-voltage (OCV) based fuel gauge estimates the available capacity of rechargeable Lithium-ion batteries using a combination of an OCV battery model and coulomb counting The OCV model measures cell voltage in the open-circuit state and determines battery capacity based on a lookup table stored in the IC
This article was originally published on Electronicstalk on 27 Aug 2002 at 8.00am (UK)
Related stories
Speedy DAC claims dynamic superiority for comms
The MAX5195 is a 14bit 260Msample/s DAC claimed to provide the world's best dynamic performance in spurious-free dynamic range, intermodulation distortion and signal to noise ratio.
Low-power serial ADC runs up to 200Ksample/s
New from Maxim Integrated Products, the MAX1162 serial-interface 16bit A/D convertor connects directly to SPI, QSPI and Microwire devices without additional interface logic.
This capability makes accurate capacity information available immediately after a battery pack is connected to the host, thus eliminating the need for a capacity learn cycle.
During periods of moderate to high discharge rates, which preclude OCV measurements, the DS2786 uses coulomb counting as a secondary means of estimating relative capacity.
Using this combination of OCV data and coulomb count, the DS2786 is able to determine pack capacity simply from a partial charge or discharge cycle, thus eliminating the need for a full charge or discharge cycle as required by many fuel-gauge ICs.
Further reading
Power amp shrinks for compact wireless networking
According to Maxim Integrated Products, the MAX2247 is the industry's smallest silicon germanium linear power amplifier for 2.4GHz WLAN applications.
Touch-screen controllers feature ESD protection
The MAX1233 and MAX1234 are programmable four-wire touch-screen controllers.
Measuring the change in coulomb count during partial charge or discharge, along with battery capacity values provided by the OCV lookup table, enables the total pack capacity to be calculated.
The accuracy of an OCV-based fuel gauge is dependent on the accuracy of the pack-voltage measurement.
The DS2786's 12bit voltage measurement is highly accurate to within +/-10mV with a resolution of 1.22mV.
In addition, the DS2786 contains two auxiliary voltage inputs that are designed to measure resistor ratios, making them ideal for measuring thermistor or pack-identification resistors.
Current is measured bidirectionally with a resolution of 11bit and an LSB value of 25uV.
Current measurements, plus a programmable offset bias, are internally accumulated at the completion of each current-measurement conversion period.
The results can be used to increment or decrement the relative-capacity value to maintain an accurate fuel gauge when conditions do not permit an OCV capacity measurement.
Internal temperature measurements are available with an accuracy of +/-3C and a resolution of 0.125C.
These measurements can be taken in place of an external thermistor measurement through one of the auxiliary voltage inputs.
The OCV lookup table and other user parameters are stored in 32 byte of on-chip EEPROM.
All measurement and estimated-capacity data are accessed through an I2C interface.
The inclusion of the I2C interface enables simple implementation on the host side of the portable product, although the DS2786 can also be mounted inside the battery pack.
Host-side mounting simplifies pack design and reduces the cost of battery-pack procurement.
Typical applications for the DS2786 include 3G multimedia handsets, digital still cameras, and digital audio (MP3) players.
The device is available in a tiny, 3 x 3mm, 10-pin TDFN package.
Prices start at US $1.22 (10,000-up).
• Maxim Integrated Products: contact details and other news
• Email this article to a colleague
• Register for the free Electronicstalk email newsletter
• Electronicstalk Home Page
